Publicité
Built-in Outdoor Grill Installation
WARNING
Excessive Weight Hazard
Use two or more people to move and install grill.
Failure to do so can result in back or other injury.
Unpack grill. Remove all packaging materials and remove grill
from carton.
Place grill into outdoor enclosure, but leave enough room in
back to connect to gas supply and electrical single prong
plug-in.
Open the hood.
Remove Packaging Material Inside the Grill
1. Cut the tiedowns holding the grates together.
2. Remove warming shelf and grill grates from inside the grill
and remove packaging material.
3. Remove foam block and wrap from inside the grill.
A
A. Foam block
B. Foam wrap
4. Replace the grill grates.
5. Place warming shelf on brackets as shown.
A
A. Warming shelf brackets
B. Warming shelf
6. Dispose of/recycle all packaging material.
14
INSTALLATION INSTRUCTIONS
B
A
Install Tank Tray for 20 lb LP Gas Fuel Tank
For Models Equipped for Use with a 20 lb LP Tank
1. Position the tank tray for 20 lb LP gas fuel tank in the island
cabinet and determine the dimension for your grill size from
the chart.
(52.4 cm)
Built-In Grill Size
27" (68.6 cm)
36" (91.4 cm)
48" (121.9 cm)
B
2. Square the tank tray mounting brackets and mark the
mounting hole locations in the island base.
3. Remove the top nuts (4) from the tank tray assembly and lift
the tank tray off of the mounting brackets.
18³⁄₈"
20⁵⁄₈"
(46.7 cm)
Dimension A
3³⁄₈" (8.6 cm)
4" (10.2 cm)
4" (10.2 cm)
A. Top nut
B. Tank tray
C. Bottom nut
D. Bolt
E. Mounting bracket
2¹⁄₄"
(5.7 cm)
A
B
Dimension B
25¹⁄₈" (63.8 cm)
34¹⁄₈" (86.7 cm)
46¹⁄₈" (117.2 cm)
A
B
C
D
E
Publicité
