Publicité
Description
806SL-0310
SELR2BDG - Recess-mounted BUS CXN transponder selector for cards, key fobs and TAG (Manchester
protocol) with blue backlighting. RAL7024 grey colour.
Technical data
MODELS
Power supply (V - 50/60 Hz)
BUS connection (CXN Unit)
Power (W)
Absorbed current (mA)
Operating temperature (°C)
Storage temperature (°C)*
Protection rating (IP)
Frequency (kHz)
Insulation class
Average life (cycles)**
(*) Before installing the product, keep it at room temperature where it has previously been stored
or transported at a very high or very low temperature.
(**) The average product life is a purely indicative estimate. It applies to compliant usage,
installation and maintenance conditions. It is also infl uenced by other factors, such as climatic and
environmental conditions.
A
Description of parts
1
Front cover
2
Transponder
3
Board protection cover
4
Rubber gasket
5
Front frame
6
Recessed gasket
7
Recessed casing
B
Control board
8
Set-up DIP switch
9
Terminal block
10
Status warning LED
7 - FA01714M4A - 10/2022 © CAME S.p.A.
C
Size
Installation
Connections and settings
For systems with more than one selector, please check the control panel or operator
SELR2BDG
manual for information on the diff erent types of wiring.
12 - 24 AC - DC
①
BUS confi guration
1
0.35
We recommend using a FROR 2x1mm² cable, maximum length from the control board:
50 m.
25
-20 ÷ +55
Do not use a shielded cable.
-25 ÷ +70
Connect the selector to the BUS terminal on the control panel.
Up to 7 BUS selectors can be connected (keypad, transponder, Bluetooth or key).
54
If there are multiple BUS selectors connected in the system, set a diff erent address for each
125
selector using DIPs 1 2 3.
III
If two selectors have the same address on the BUS, the backlighting fl ashes red to
500000
highlight the confi guration error.
②
Configuring R700 V2 / S0002P
We recommend using a FROR 2 x 1 mm cable, maximum 30 m in length from the
control board.
Connect the selector to terminals S1-GND on the electrical panel.
Set DIP 1 2 3 to OFF.
Interface board
R700
R700 V2
S0002P
Backlighting
Set DIP 4 to ON to activate the selector backlighting.
When the device is in standby mode, the backlighting is blue.
Final operations
D
E
G
Number of selectors that can be
connected
1
2
4
Publicité
