EINHELL TP-AG 18/125 F Li BL Instructions D'origine page 19

4. Technical data
Motor power supply: ............................... 18 V DC
Rated speed: .......................................8500 min
Max. wheel diameter: ............................. 125 mm
Grinding wheels: ............................ 125 x 22 mm
Cutting wheel: ................................ 125 x 22 mm
Mounting spindle thread: ............................. M14
Weight: .......................................................1.7 kg
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 62841.
L sound pressure level ........................ 89 dB(A)
pA
K uncertainty ............................................. 5 dB
pA
L sound power level ........................... 97 dB(A)
WA
K uncertainty ............................................. 5 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 62841.
Vibration emission value a
K uncertainty = 1.5 m/s
The stated vibration emission levels and stated
noise emission values were measured in accord-
ance with a set of standardized criteria and can
be used to compare one power tool with another.
The stated vibration emission levels and stated
noise emission values can also be used to make
an initial assessment of exposure.
Warning:
The vibration and noise emission levels may
vary from the level specifi ed during actual use,
depending on the way in which the power tool is
used, especially the type of workpiece it is used
for.
Anl_TP_AG_18_125_F_Li_BL_SPK13.indb 19 Anl_TP_AG_18_125_F_Li_BL_SPK13.indb 19
-1
= 8,106 m/s
2
hAG
2
- 19 -
GB
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
5. Before starting the equipment
Warning!
Always remove the battery pack before making
adjustments to the equipment.
5.1 Fitting the additional handle (Fig. 2)
•
The angle grinder must not be used without
the additional handle (3).
•
The additional handle can be secured in any
of two positions (A, B).
Tool side
Left (position A / as
shown)
Right (position B)
5.2 Adjusting the guard (Fig. 3)
•
The guard (4) is equipped with an automatic
latching function so that it can be adjusted wi-
thout you having to release a lever or similar.
•
To protect your hands, adjust the guard (4) so
that the ground material is directed away from
your body.
Suitable for
Right-handed users
Left-handed users
04.06.2024 11:16:40 04.06.2024 11:16:40