Technical Data; Before Starting The Equipment - EINHELL CC-HS 12/1 Instructions D'origine

4. Technical data

Max. loosening torque ..............................350 Nm
Operating voltage ................................... 12 V DC
Power rating ............................................... 80 W
Working range (max. thread size) ................ M14
Square drive mount ................12.7 mm (1/2 inch)
Weight .......................................................1.7 kg
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level ........................ 86 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level .......................... 97 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
Vibration emission value a
K uncertainty = 1.5 m/s
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Anl_CC_HS_12_1_SPK9.indb 16 Anl_CC_HS_12_1_SPK9.indb 16
= 4.27 m/s
2
h
2
- 16 -
GB
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
Limit the operating time!
All stages of the operating cycle must be conside-
red (for example, times in which the electric tools
are switched off and times in which the tool is
switched on but operates without load).

5. Before starting the equipment

Use only drive socket inserts which are suitable
for the purpose and in faultless condition.
Note: This tool is equipped with a centrifugal
clutch.
A) When the drive socket insert fi tted to the
square drive mount is placed on the wheel
nut/wheel bolt, this will result in the motor
being loaded. The motor will run without the
drive socket insert turning. Using the cen-
trifugal clutch, the motor builds up torque
and performs short impact movements on
the drive socket insert when this torque is
reached. As the result, the wheel nut/wheel
bolt will be tightened or slackened.
B) When the motor is not loaded, the square
drive mount or the fi tted drive socket insert
will rotate. Caution! Never hold the square
drive mount or the fi tted drive socket insert
with your hand. You could be injured by a sud-
den impact movement.
19.05.2020 11:03:04 19.05.2020 11:03:04