Publicité
6
PRE-ARRANGED JUMPER HARNESS CONNECTIONS, continued
4. Secure the pre-arranged wire harness to the vehicle's
wire harness using two (2) of the supplied 39cm tie
wraps. Trim off the excess tie wraps. (FIGURE N)
Secure the supplied remote engine start wire harness to
the vehicle's wire harness using one (1) of the supplied
39cm tie wraps. Trim off the excess tie wrap.
(FIGURE N)
5. Plug the supplied remote engine start wire harness
8-pin connector into the 8-pin port on the remote engine
start ECU, previously mounted to the back side of the
glove box inner cover (SECTION 5). (FIGURE O)
ISSUE
PART NUMBER
H001SSL000
DATE
00
8 Jun 2023
FIGURE N
FIGURE O
SUBARU OF AMERICA
6 OF 11
Publicité
