Publicité
6
PRE-ARRANGED JUMPER HARNESS CONNECTIONS
1. Locate the vehicle's 12-pin pre-arranged connector that
is secured to the vehicle's wire harness with breakaway
tape near the upper passenger's side glove box area.
(FIGURE K)
2. Release the vehicle's 12-pin pre-arranged connector
from the breakaway tape. (FIGURE L)
3. Plug the supplied remote engine start wire harness
12-pin connector into the corresponding 12-pin pre-
arranged connector. (FIGURE M)
NOTE: The remote engine start 8-pin connector
(taped to the supplied remote engine start wire
harness) is not used/applicable on Push start
models.
PART NUMBER
ISSUE
H001SSL000
DATE
00
8 Jun 2023
FIGURE K
12-Pin
Pre-arranged
Connector
FIGURE L
Not used on
Push start
models
FIGURE M
SUBARU OF AMERICA
5 OF 11
Publicité
