Publicité
The device becomes very hot during operation! Only touch the control
panel 10 min after switching off. Never reach into the air flow, the chimney
connection or the exhaust pipe during operation!
Observe minimum distances.
Equipment damage and environmental damage is imminent.
Cable connections may become loose during operation.
Check all visible cable connections for tightness.
Check the fuel system for leaks before every start!
3m
Abb.16
The device has a built-in overheating protection. If the internal device temperature is
too high, the fan motor is automatically switched on. This also applies when the device
is switched off.
The device has an automatic interruption of the fuel supply. If the device does not
ignite, the fuel supply is interrupted. A photocell serves as a sensor. The fan will
automatically run for 90 seconds.
• Make sure that the device is fueled.
• Plug the power cord into a suitable power outlet.
• The set temperature display (on the left of the control panel) shows "--". The actual
temperature display (on the right side of the control panel) shows the current room
temperature.
22
Commissioning
2m
3m
2m
2m
V. 1.0
EN
Publicité
