Publicité
REPLACING FUSES
If the fuse blows, determine the cause, then correct the problem. After the
problem is resolved, replace the fuse. If newly installed fuses continue to blow,
disconnect the power cable and contact your authorized KENWOOD dealer or an
authorized KENWOOD service center for assistance.
Fuse Location
Transceiver
(located on the DC connector)
Supplied DC power cable
Only use fuses of the specifi ed type and rating; otherwise the transceiver could be damaged.
OPERATION PANEL AND MICROPHONE CONNECTION
Plug the microphone plug into the MIC jack, then connect the Operation panel to
the TX/ RX unit with the supplied cable.
•
Attach the microphone hanger to an appropriate position using the screws included in
the screw set.
Microphone
MIC jack
Modular plug cable
6
Fuse
Fuse holder
TX/ RX unit
Line fi lter
Line fi lter
Fuse Current Rating
15 A
20 A
Installing the Line Filter
Install the line fi lters
approximately 3 cm from the
connectors.
Approx. 3 cm
Panel jack
Operation panel
Publicité
