Publicité
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be
performed. Use of the power tool for operations different from those intended
could result in a hazardous situation.
h) Keep handles and grasping surfaces dry, clean and free from oil and grease.
Slippery handles and grasping surfaces do not allow for safe handling and control
of the tool in unexpected situations.
i) Please confirm the number of voltage volts before use. The working voltage is
not more than ±5%. If it is more than that, it will cause motor burning and leakage
accidents.
j) During construction, please pay attention to avoid water entering the motor or
blocking the ventilation hole, so as not to reduce the heat dissipation performance
of the motor and cause the motor to burn down.
k) In the steel plate construction, please pay attention to the safety of the lower
layer of personnel and goods, iron beam and column drilling, pay attention to the
safety of the structure of the building.
L) In suspension operation, the safety belt must be tightly tied and the magnetic
drill fixed to prevent sudden power failure or power failure caused by accidents.
M) Do not cut the power cord or change the plug yourself. This will cause the
machine to burn out.
Service
a) Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
b) In any case, it should be started in no-load state. It is forbidden to start with
load, so as to avoid damage to the machine. Please pay attention to the stability
of the magnetic drill when working at high altitude, so as to prevent the machine
from falling down.
c) Ensure that the ground cable is grounded reliably.
d) When moving, the magnetic drill should be lifted to prevent damage to the
magnetic base.
e) In the maintenance must use the original parts, in order to make the machine
to achieve the best use state.
7
Publicité
