Publicité
DIAMOND CORE DRILL SAFETY WARNINGS
1. Use auxiliary handles supplied with the tool. Loss of control can cause
personal injury.
2. Consider work area environment: Don't use diamond core drill in damp or wet
locations. Don't expose diamond core drill to rain. Keep work area well-lit. In
particular no inflammable liquids or gases must be present. The series motor
produce sparks during normal rotating, the sparks may cause the risk of fire.
3. Grounding of class I tools is necessary while in use to protect you from electric
shock, class I tools is equipped with an approved three-conductor cord and
three-prong grounding-type plug, the green/yellow conductor in the cord is the
grounding wire, one end of wire is in the grounding sign of tool outer shell, the
other end of wire is connected with the ground wire of plug. Never connect the
green/yellow wire to a live terminal.
4. The socket must fitted with grounding. Do not insert class I tools into the socket
without grounding.
5. Use extension cords when tool is used outdoors or indoors, use special
extension wire board. Use only three-conductor cord and with reliable grounding.
6. Take care of downward direction in the high position, safety belt and safety cap
etc are recommended.
7. In order to avoid unintentional electric shock, please check the grounding
condition of electrified body in working area before operating, it is not allowed to
operate the tool under the uncertain condition, once the drill bit touched the
electrified body in the wall, floorboard or baseboard, the electrified outer shell of
drill may cause personal injuries.
8. The safety equipment is recommended when drilling on high the ceiling to
avoid the drill core injuring the persons downstairs or damaging the property
downstairs.
9. Connecting the soft pipe with the inner
9mm to the adaptor of the valve.
Φ
10. Please make sure that there is no leak of water in order that it will not damp
the motor when you use the liquid and the attachments.
11. Usually inspect the hoses and other critical parts of the tool which could
deteriorate; When appear of leak of water from the testing hole of the gear box,
must turn off the tool immediately then replacing the rubber seal.
9
Publicité
