Publicité
EN
PREPARATION
• Do not fill the tank with too much fuel or it will overflow when the tank gets warm.
• After refuelling, make sure to put the cap back in place and tighten it.
• Wipe off any spilled fuel with a clean, soft cloth after refueling.
Note: You must only use unleaded gasoline. Filling the fuel tank with leaded gasoline
can damage the internal parts of the engine.
10W-30
5W-30
-20
0
20
40
60
-20
-10
0
10
Fig. 7
Oil drain bolt
• Pull the starter handle up gently until resistance is felt, then pull it out quickly.
Note: After starting, do not let the starting rope return to its original position rapidly, instead, let it
return to its original position slowly.
OFF
ON
Fig. 11
Ground terminal (Fig. 12, Fig. 13)
• The grounding terminal is connected to the ground wire to prevent electric shock. When the
electrical equipment is grounded, the generator must be grounded.
• The ground terminal is a special terminal used to ground the entire generator.
Fig. 13
9
Add fuel (Fig. 6)
15W-40
• The generator is not filled with engine oil from the factory. Do not start the generator without
adding enough engine oil.
• Add oil that meets or exceeds the service level requirements of SG and FG.
• The engine oil grade SG and FG will be marked outside the oil container.
• Follow the chart (fig. 7) to choose the right engine oil taking into account the temperature of your
80
100
°F
area.
20
30
40
°C
Oil dipstick
Fig. 8
Fig. 9
Recoil starter (Fig. 10)
• The fuel tap controls the flow of fuel from the tank to the carburetor.
• Make sure to set the fuel tap to the ''OFF'' position after turning off the generator.
Ground terminal
WWW.NIKOLAOUTOOLS.GR
Fuel tank cap
Loosen
Add engine oil (Fig. 7, Fig. 8, Fig. 9)
Oil upper limit
Oil lower limit
Recoil starter
Fuel tap (Fig. 11)
Max. level of fuel
Fuel gauge
Tighten
Fuel filter
Fig. 6
Fig. 10
Fig. 12
Ground terminal
Publicité
