Publicité
EN
GENERATOR USE
• Appropriate temperature: -5°C - 40°C
• Appropriate humidity: below 95%
• Appropriate altitude: below 1000m (lower power should be used in areas above 1000m or contact the supplier to adjust the carburetor)
Connect to a house power supply
Warning: Only specialist electricians should connect the generator as a house power supply.
AC output
• Before starting the generator, ensure that the total power of the connected load will not exceed the rated power of the generator.
Note: • The connection of loads to the generator that exceed its rated power can cause the generator to shut down or significantly shorten its life.
• If several loads are to be connected to the generator set, always remember to first switch on the load with the highest starting current and finally
switch on the load with the lowest starting current.
STARTING THE GENERATOR
Recoil start
1) Remove all loads from the output.
2) Set the ignition switch to the ''ON'' position.
3) Set fuel tap to the ''ON'' position.
4) Set the AC circuit protector* to the ''OFF'' position.
5) Set the choke valve handle to the ''OFF'' position.
Note: Do not close the choke valve when the gasoline engine is started while it is in a hot state.
6) Pull the starter handle up gently until you feel resistance and then pull it out quickly.
7) When the generator is started, slowly place the choke valve handle in the "ON" position.
8) Set the AC circuit protector* to the ''ON'' position before using the electrical load.
*: Only applies if the generator is equipped with an AC circuit protector.
STOPPING THE GENERATOR
1) Turn off the AC circuit protector*.
2) Turn off the ignition switch of the generator.
3) Turn off the fuel tap.
4) Disconnect all electrical equipment.
Note: To stop the generator in an emergency, set the generator switch to the "OFF" position.
*: Only applies if the generator is equipped with an AC circuit protector.
MAINTENANCE
In order to keep the unit in good condition, it must be checked and maintained on a regular basis. Follow the table below.
Item
Engine oil
Gearbox gear oil (if any)
Air filter element
Precipitation cup (if any)
Spark plug
Spark arrester
Idle (if any)**
Fuel tank and filter
Fuel oil pipe
Cylinder head piston
*: These items should be replaced if necessary
**: These items should be maintained only by authorized service personnel
10
RECOMMENDED MAINTENANCE SCHEDULE
Frequency
Each use
Action
Check - Refill
X
Replace
X
Check oil level
Replace
Check
X
Clean
Replace
Clean
Check - Adjust
Clean
Check - Adjust
Clean
Check
Remove carbon
deposits**
WWW.NIKOLAOUTOOLS.GR
First month or
Every 3 months or
each 20 hours
each 50 hours
X
X
X
X
X
X
X
X
Every 2 years (replace it if necessary)
Displacement < 225 cc, every 125 hours
Displacement ≧ 225 cc, every 250 hours
Every year
X
X*
X
X
Publicité
