Publicité
BEFORE INSTALLING
Read this installation manual completely before installing the rooftop air conditioner.
The following tips and instructions must be observed while installing the rooftop air conditioner.
What's in the Boxes
Open and remove the components from the cartons. Make
sure you have all the following items included in the packaging,
if any item is missing, contact your dealer.
• (A) Rooftop Unit x 1
• (B) Mounting Frame x 1
• (C) Foam Divider x 1
• (D) Mounting Bolts (Long) x 4
• (E) ADB Shroud x 1
• (F) Filter x 1
• (G) Electrical Box Screws x 2
• (H) Mounting Bolts (Short) x 5
• (I) Electrical Box x 1
• (J) Electrical Box Cover x 1
• (K) Remote (Select models only) x 1
• (-) Adhesive Insulation Foam (Not Shown) x 1
• (-) Instruction Manual (Not Shown) x 1
• (-) Refrigerant Manial (Not Shown) x 1
• (-) Warranty Manual (Not Shown) x 1
Choosing the Proper Location
for the Air Conditioner
NOTE: The roof must be designed to support the weight of the
rooftop unit and the weight of 2 installers standing on the roof.
There are two ways of installing the rooftop air conditioner:
1. Using the existing roof vent opening in the vehicle roof.
2. Making a new opening. In this case the opening should be
reinforced by an appropriate frame as required.
Existing Roof Vent Opening
The air conditioner is designed to fit over an existing 14" roof
vent opening.
New Opening
When no roof vent is available or another location is desired,
the following is recommended:
• For one unit installation the air conditioner should be mounted
near the rear and centered from side to side.
• For two unit installations, install one air conditioner near the
rear of the RV and the other air conditioner less than two
thirds from the rear of the RV, aligned in the center.
It is preferred that the air conditioner be installed on a relatively
flat and horizontal roof section measured when the RV is
parked on a level surface.
NOTE: A 15° slant to either side or front to back is acceptable
for all units. If the roof exceeds 15° please use an exterior
leveling shim to make air conditioner level.
H
I
J
E
After the Location Has Been Selected:
1. Check for obstructions in the area where the air conditioner
will be installed.
2. Check the inside of the RV for return air kit obstructions. (i.e.
door openings, room dividers, curtains, ceiling fixtures, etc.)
Allow 6" (152mm) space from the opening to account for any
potential return air kit obstructions.
18"
Roof opening
Center line of
rooftop
Keep this air flow area free of
obstructions
- 5 -
F
C
B
Rooftop View
CCD-0008919 Rev: 07.30.24
A
G
D
K
Publicité
