Publicité
Handling the Remote Control
NOTE: Remote not available for all units.
NOTE: Remote requires 2 AAA batteries. Some models come
with included batteries.
Inserting and Replacing Batteries
1. Slide the back cover from the remote control downward,
exposing the battery compartment.
2. Insert the AAA batteries, matching the (+) and (-) ends of the
batteries with the symbols inside the battery compartment.
3. Slide the battery cover back into place.
NOTE: For optimum product performance, do not mix old and
new batteries or batteries of different types
NOTE: Do not leave batteries in the remote control if you don't
plan on using the device for more than 2 months.
Battery Disposal
Do not dispose of batteries as unsorted municipal waste. Refer
to local laws for proper disposal of batteries.
Quick Start Guide
Insert batteries
into remote
Press power button
Using the Remote
• The remote control must be used within 26.25 feet (8 meters)
of the unit.
• The unit will beep when remote signal is received.
• Curtains, other obstructions, and direct sunlight can interfere
with the infrared signal receiver.
Remote Notes
This device complies with the local national regulations.
In Canada, it should comply with CAN ICES-3(B)/NMB-3(B).
In the USA, this device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Changes or modifications not approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
Select mode:
AUTO → COOL → DRY → FAN
Point remote towards unit
- 15 -
Select
temperature
Select fan speed
CCD-0008919 Rev: 07.30.24
Publicité
