Publicité
2. Install the ADB shroud over the mounting frame and fix with
the 5 provided long screws, or #8 x1.5" (max) pan head RV
screws can also be used.
NOTE: Make sure the "THIS WAY FRONT" mark is facing front
(the direction of the vehicle) while installing.
3. Remove wire mesh filter from the ADB to access the wires in
the return by removing the two screws and snapping the mesh
out of the mounting frame.
4. Connect the Chill Cube wires from the control box to the
wires from the faceplate of the ADB. Connect the black, main
control connectors together, and the blue temperature sensor
connectors together. Tuck the white connection off to the side,
unused
CCD-0008919 Rev: 07.30.24
5. Place loose wires inside the electrical box, and close the
electrical box panel door. Secure the panel door shut using the
screw provided.
6. Replace the wire mesh filter in the ADB shroud using the
two screws provided.
7. Replace the ADB filter cover over the filter, and close the
swivel door.
Your new rooftop air conditioner has now been fully installed in
the RV roof.
- 12 -
Publicité
