Publicité
3. Dry fit the mounting frame, making sure the "THIS WAY
FRONT" mark is facing front (the direction of the vehicle), and
measure the gap from the top of the insulated foam divider to
the base of the AC unit. Record this measurement.
XX"
4. Cut and remove an amount of the top insulation foam divider
equal to the recorded measurement height.
5. Measure the new height of the insulated foam divider. Cut
enough adhesive insulation foam to fully cover the foam
insulation divider, and adhere the adhesive insulation to the
divider.
6. Connect the insulated top foam divider to the mounting
frame and seal any cracks.
CCD-0008919 Rev: 07.30.24
7. Install the assembled mounting frame into the rooftop
opening.
Roof opening
8. Fix the assembled mounting frame into the rooftop unit
using 4 bolts provided. Evenly tighten the four bolts to a torque
of 40 inch pounds. This will compress the roof gasket to
1/2
approximately
".
NOTE: If bolts are left loose there may not be an adequate
roof seal or if over tightened, damage may occur to the rooftop
base or mounting frame.
- 10 -
Publicité
