Publicité
Operating the Timer Function
Press the TIMER ON button to set the auto-on time of the unit.
Press the TIMER OFF button to set the auto off time of the unit
To set the Auto-on time
1. Press the TIMER ON button. The remote control LCD
display will read TIMER ON, the last Auto-on setting time, and
the letter "H".
2. Push the TIMER ON button again to set desired Auto-on
time. Each time the button is pressed, the time will increase
by half hour increments up to 10 hours, and then by one hour
increments between 10 and 24 hours.
3. After setting the TIMER ON there will be a one second delay
before the remote transmits the signal to the air conditioner.
Then, after approximately another two seconds, the letter "H"
will disappear from the LCD display and the set temperature
will re-appear.
Examples of Setting the Timer
To set the Auto-off time
1. Press the TIMER OFF button. The remote control LCD
display will read TIMER OFF, the last Auto-off setting time, and
the letter "H"
2. Press the TIMER OFF button again to set the desired Auto-
off time. Each time the button is pressed, the time will increase
by half hour increments up to 10 hours, and then by one hour
increments between 10 and 24 hours.
3. After setting the TIMER OFF there will be a one second
delay before the remote transmits the signal to the air
conditioner. Then, after approximately another two seconds,
the letter "H" will disappear from the LCD display and the set
temperature will re-appear.
• When selecting timer operation, the remote control
automatically transmits the timer signal to the indoor unit
for the specified time. Keep the remote in a location where
it can transmit the signal to the indoor unit properly within
range of the unit.
• The effective operation time set by the remote control for
the timer function is limited to the following settings: 0.5,
1.0, 1.5, 2.0, 2.5, 3.0, 3.5, 4.0, 4.5, 5.0, 5.5, 6.0, 6.5, 7.0,
7.5, 8.0, 8.5, 9.0, 9.5, 10, 11, 12, 13, 14, 15,16,17, 18, 19, 20,
21, 22, 23 and 24.
TIMER ON (Auto-on Operation)
The TIMER ON feature is useful for turning the unit on
automatically before returning home. The air conditioner will
automatically start operating at the set time.
Example:
To start the air conditioner in 6 hours -
1. Press the TIMER ON button. The previous start time setting
and the letter "H" will be displayed on the remote's LCD display.
2. Press the TIMER ON button again as needed to cycle
through times until "6.0H" is displayed.
3. Wait for 3 seconds or until the display shows the
temperature again. The "TIMER ON" indicator will remain on
and the function is activated. The Air conditioner will turn itself
on in 6 hours.
- 17 -
CAUTION
CCD-0008919 Rev: 07.30.24
Publicité
