Publicité
Reflection of radio waves
The radio waves communicated to this product include radio waves arriving
directly (direct waves), and radio waves reflected off walls, furniture, the
building, etc., arriving from various directions (reflected waves). In this
way, various reflected waves are generated from obstacles and reflectors,
resulting in locations where the radio signal is good and locations where it
is bad, so in some cases, the audio reception may not be good.
In such cases, try slightly moving the location of the Bluetooth device. In
some cases, the sound may be cut off by the effect of reflected waves, due
to a person passing between or approaching the Bluetooth device and the
product.
CAUTION
• Please note that Pioneer does not accept any responsibility for damage
caused by the use of the product, except in cases where liability for
compensation is recognized by law.
• This product is not guaranteed to be able to connect to and operate with
all types of Bluetooth devices.
For safe use of the product
• Do not use this product close to electronic devices that handle signals
for high-precision control or weak signals. This could cause electronic
devices to malfunction, resulting in an accident.
• Do not use the product in places where its use is prohibited, such as on
aircraft or in hospitals. This could affect electronic devices or medical
electrical devices, resulting in an accident. Follow the instructions of the
medical establishment.
Examples of electronic devices to be careful about
Hearing aids, pacemakers, other medical electrical devices, fire alarms,
automatic doors, other automatic control devices, etc.
People who use a pacemaker or other medical electrical device should
check with the manufacturer or distributor of the medical electrical device
regarding the effect of radio waves.
Besides microwave ovens and other similar industrial, scientific, and
medical devices, the frequency band used by this device is also used
for operation of internal wireless stations for identifying moving objects
as used in production lines in factories, etc. (wireless stations requiring
a permit), specified low-power radio stations (wireless stations not
requiring a permit), and amateur radio stations (wireless stations
requiring a permit).
1. Before using this device, check whether internal wireless stations
for identifying moving objects, specified low-power radio stations, or
amateur radio stations are operating nearby.
2. In the event that there is an occurrence of harmful radio wave
interference from this device to an internal wireless station for
identifying moving objects, immediately stop the emission of the radio
waves, contact the help desk, and discuss measures for preventing
interference (for example, installation of a partition).
3. In the event of occurrence of other problems, such as harmful radio
wave interference from this device to a specified low-power radio
station for identifying moving objects or amateur radio station, consult
with the help desk.
Others
Cleaning the product
• Wipe the product with a soft cloth for regular cleaning.
• If the product is very dirty, immerse a soft cloth in a neutral cleaning agent
diluted with water 5 to 6 times the volume of cleaning agent, wring the
cloth well, wipe off the dirt, and then wipe it again with a dry cloth. Note
that if alcohol, thinner, benzene, insecticide, etc., adheres to the product,
it will cause peeling of the print and paint. Also, if a chemical cloth or
similar is used, thoroughly read the cautions provided with the chemical
cloth.
6
Publicité
