Publicité
6.2
Switching on and off
Always guide the machine with both hands.
Switch on first, then guide the accessory
towards the workpiece.
The machine must not be allowed to draw in
additional dust and shavings. When switching
the machine on and off and keep it away from dust
deposits. After switching off the machine, only place
it down when the motor has come to a standstill.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine with
both hands using the handles provided, stand
securely and concentrate.
SVB 18 LTX BL 200:
Switching on: push the slide switch (7) forwards.
For continuous operation, tilt it downwards
until it engages.
Switching off: press the rear end of the slide switch
(7) and release it.
PE 17-200 RT:
Torque activation (with dead man's lever)
I
Switching on: Slide the trigger switch (12)
forwards and then push the trigger switch
(12) upwards.
Switching off: Release the trigger switch (12).
Continuous operation (depending on features)
I
Switching on: Switch the machine on as described
above. Now slide the trigger switch (12)
forwards again and release in the front
position to lock the trigger switch (12)
(continuous operation).
Switching off: Push the trigger switch (12)
upwards and release.
7. Attaching the tools, working
notes
Press in the spindle locking knob (8) only
when the spindle is stationary!
12
0
12
0
7.1
Tools with threaded insert:
1. Remove the tensioning spindle (14) if
necessary. Press in spindle locking button (8)
and hold in place. Unscrew the tensioning
spindle using the open-ended spanner (15).
2. Press in spindle locking button and hold in place.
3. Screw the tool onto the spindle and tighten.
7.2
Tools for tensioning spindle:
- Attach the tensioning spindle (14) if necessary.
Press in spindle locking button (8) and hold in
place. Tighten the tensioning spindle using the
open-ended spanner (15).
- Slide the tool onto the tensioning spindle.
- Press in spindle locking button (8) and hold in
place.
- Screw the tool fixing screw (13) onto the
tensioning spindle and tighten (the spindle locking
knob engages and the tool can be secured).
If the tools used are shorter than the
tensioning spindle, insert the relevant distance
sleeves (16). This is the only way to properly secure
the tool.
7.3
Working Directions
Sanding, polishing, working with wire brushes:
Apply moderate pressure on the machine and move
it to and fro across the surface
8. Maintenance
Disconnect the mains plug or remove the battery
pack from the machine before starting any
maintenance work.
Particles may become deposited inside the power
tool during operation. This impairs the cooling of the
power tool. Conductive build-up can impair the
protective insulation of the power tool and create an
electrical hazard.
The power tool should be cleaned regularly, often
and thoroughly through all front and rear air vents
using a vacuum cleaner or by blowing in dry air.
Prior to this operation, separate the power tool from
the power source and wear protective glasses and
dust mask.
9. Cleaning
Particles may become deposited inside the power
tool during operation. This impairs the cooling of the
power tool. Conductive build-up can impair the
protective insulation of the power tool and create an
electrical hazard.
The power tool should be cleaned regularly, often
and thoroughly through all front and rear air vents
using a vacuum cleaner or by blowing in dry air.
Prior to this operation, separate the power tool from
the power source and wear protective glasses and
a suitable dust mask. Ensure appropriate suction is
available when blowing out vents.
ENGLISH en
9
Publicité
