Publicité
A damaged or cracked side handle must be
replaced. Never operate the machine with a
defective additional handle.
Only use the machine if the protective cover is in
place.
Always guide the machine with both hands on the
handles provided.
Do not reach into rotating accessories!
3.7
Special safety instructions for mains
powered machines:
Pull the plug out of the socket before making any
adjustments, changing tools, carrying out
maintenance or cleaning.
Before connecting the mains plug, make sure that
the machine is switched off.
Use of a fixed extractor system is recommended.
Always install an RCD / GFCI with a maximum trip
current of 30 mA upstream. If the angle grinder is
shut down via the GFCI, it must be checked and
cleaned. See Chapter 8. Maintenance.
3.8
Special safety instructions for cordless
machines:
Remove the battery pack from the machine before
making any adjustments, changing tools,
maintaining or cleaning.
Before fitting the battery pack, make sure that the
machine is switched off.
Protect battery packs from water and
moisture!
Do not expose battery packs to fire!
Do not use faulty or deformed battery packs!
Do not open battery packs!
Do not touch or short circuit battery pack contacts!
A slightly acidic, flammable fluid may leak
from defective Li-Ion battery packs!
If battery fluid leaks out and comes into
contact with your skin, rinse immediately
with plenty of water. If battery fluid leaks out
and comes into contact with your eyes, wash them
with clean water and seek medical attention
immediately!
If the machine is defective, remove the battery pack
from the machine.
Transport of Li-Ion battery packs:
The shipping of Li-Ion battery packs is subject to
laws related to the carriage of hazardous goods (UN
3480 and UN 3481). Inform yourself of the currently
valid specifications when shipping Li-Ion battery
packs. If necessary, consult your freight forwarder.
Certified packaging is available from Metabo.
Only send the battery pack if the housing is intact
and no fluid is leaking. Remove the battery pack
from the machine for sending. Prevent the contacts
from short-circuiting (e.g. by protecting them with
adhesive tape).
Additional Warnings:
Some dust created by power
sanding, sawing, grinding,
drilling, and other construction activities
contains chemicals known to cause cancer,
birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and
other masonry products, and
• Arsenic and chromium from chemicallytreated
lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are
specially designed to filter out microscopic
particles.
SYMBOLS ON THE TOOL:
.......... Class II Construction
V ............. volts
A ............. amperes
Hz ........... hertz
.../min...... revolutions per minute
~ ............. alternating current
........... direct current
nrated speed
4. Overview
See page 2.
1 Additional handle
2 Safety guard
3 Handle bar
4 Clamping lever
5 Screw
6 Handle
7 Sliding on/off switch*
8 Spindle locking button
9 Spindle
10 Electronic signal indicator
11 Speed adjustment wheel*
12 Pushbutton switch*
13 Tool fixing screw
14 Tensioning spindle (with 2 captive fitted keys)
15 Open-ended spanner
16 Distance sleeves (for tools shorter than the
tensioning spindle)
17 Battery pack release button*
18 Dust filter*
19 Battery pack *
20 Button of capacity display*
21 Capacity and signal display*
22 Locking button
*depends on features / model
ENGLISH en
California Prop 65 08_2018
7
Publicité
