Télécharger Imprimer la page

Metabo SVB 18 LTX BL 200 Mode D'emploi page 10

Publicité

en
ENGLISH
10. Troubleshooting
10.1 Mains powered machines
The electronic signal indicator (10) lights
up and the load speed decreases (not
W...RT). There is too much load on the
machine! Run the machine in idling until the
electronic signal indicator switches off.
The machine does not start. The
electronic signal indicator (10)
(depending on the model) flashes. Restart
protection is active. If the mains plug is inserted with
the machine switched on or if the power supply is
restored following an interruption, the machine
does not start up. Switch the machine off and back
on again.
10.2 Cordless machines
The electronic signal display (10) flashes
and the machine does not start.
The battery pack is empty; the temperature is
too high or the restart protection has triggered.
Switch the machine off and back on again.
The machine will not start if the battery pack is
inserted while the machine is on.
When using a battery pack that is not part of CAS,
the machine will not start.
The electronic signal display (10) is
permanently on.
There has been an overload while working,
therefore the performance may be reduced
temporarily. Reduce working pressure.
Electronic safety shutdown: the machine has
SHUT DOWN by itself. If the slew rate of the
current is too high (for example, if the machine
suddenly seizes or kickback occurs), the machine
switches off. Switch off the machine. Switch it on
again and continue to work as normal. Try to
prevent the machine from seizing.
11. Accessories
Always use the suitable accessory for the
application.
Application:
1 = burnishing, texturing and matting stainless steel
surfaces and non-ferrous metals
2 = removing scratches and cleaning surfaces
3 = polishing, fine grinding, deburring
4 = smoothing / roughening wooden materials
Accessories:
1.1 = sanding fleece roller
1.2 = fleece sanding sleeve (only in conjunction with
expansion roller)
1.3 = flap grinding wheel
1.4 = flap/fleece grinding wheel
1.5 = fleece grinding wheel
1.6 = rubber grinding wheel
1.7 = "Metabo Pyramid", sanding belt 90 x 100 mm
1.8 = Inox steel wire round brushes
1.9 = plastic round brushes
2.1 = sanding fleece roller
2.2 = fleece sanding sleeve (only in conjunction with
10
expansion roller)
2.3 = hard fleece grinding wheel
2.4 = flap grinding wheel
2.5 = flap/fleece grinding wheel
2.6 = rubber grinding wheel
2.7 = zircon corundum sanding belt, 90 x 100 mm
(only in conjunction with expansion roller)
2.8 = brass steel wire round brushes
2.9 = Inox steel wire round brushes
3.1 = fleece sanding sleeve (only in conjunction with
expansion roller)
3.2 = fleece grinding wheel
3.3 = fleece belts
3.4 = felt belt 30x600 mm (only in conjunction with
sanding belt roll 623529000)
3.5 = Inox steel wire round brushes
3.6 = plastic round brushes
3.7 = polishing rings and abrasive pastes
4.1 = flap/fleece grinding wheel
4.2 = fleece grinding wheel
4.3 = brass steel wire round brushes
4.4 = plastic round brushes
4.5 = fibre round brush
Only use original Metabo battery packs and Metabo
accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
Chargers: ASC 55, ASC 145, etc.
Battery packs with different capacities. Buy
battery packs only with voltage suitable for your
power tool.
Order no.: 625368000 5.5 Ah (LiHD)
Order no.: 625369000 8.0 Ah (LiHD)
Order no.: 625549000 10.0 Ah (LiHD)
etc.
Order no.: 625591 ..... 4.0 Ah (LiPOWER)
Order no.: 625028 ..... 5.2 Ah (LiPOWER)
etc.
Polishing rings
Auxiliary materials for polishing
See www.metabo.com or the catalogue for a
complete range of accessories.
12. Repairs
Repairs to electrical tools must only be carried
out by qualified electricians!
A defective mains cable must be replaced only with
a special, original mains cable from Metabo
available from the Metabo service.
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.
13. Environmental Protection
The generated sanding dust may contain harmful
substances: dispose of appropriately.

Publicité

loading

Ce manuel est également adapté pour:

Se 17-200 rt