Publicité
CODE
The battery voltage is still under 10 V
F01
(for a 12 V battery) or 5 V (for a 6 V battery)
after 2 hours of charging.
F02
The charger cannot desulfate the battery.
The battery was unable to reach the "full
F03
charge" voltage.
F04
The connections to the battery are reversed.
The charger was unable to keep the battery
F05
fully charged in maintain mode.
The charger detected that the battery may be
F06
getting too hot (thermal runaway).
The charger shut off because its internal
F07
temperature exceeds limit.
The battery voltage dropped too low during
F08
the maintain mode.
NOTE:
If you get an error code, check the connections and settings and/or replace the battery.
DESCRIPTION
REASON/SOLUTION
The battery could be bad. Have it checked or
replaced.
The battery could not be desulfated; have it
checked or replaced.
May be caused by trying to charge a large
battery or bank of batteries on too low of a
current setting. Try again with a higher current
setting, or have the battery checked or replaced.
The battery is connected backwards.
Unplug the charger and reverse the
connections to the battery.
The battery won't hold a charge. May be caused
by a drain on the battery or the battery could
be bad. Make sure there are no loads on the
battery. If there are, remove them. If there are
none, have the battery checked or replaced.
The charger automatically shuts the current off
if it detects the battery may be getting too hot.
Have the battery checked or replaced.
Make sure the charger does not have the side
ventilation holes blocked. Move the charger out
of the sun and into the shade.
May be caused by a drain on the battery or the
battery could be bad. Make sure there are no
loads on the battery. If there are, remove them.
If there are none, have the battery checked or
replaced.
17
Publicité
