Publicité
• Never insert tips and/or metallic objects
into the product.
• Symbols appearing on your product may
not be removed or covered. Information
notices on the product that are no longer
legible must be replaced immediately.
Read and observe the operating in-
structions before commissioning.
Personal safety equipment
Wear hearing protection.
Wear protective goggles.
Wear a dust mask.
Your product at a glance
Note: The actual appearance of your
device may differ from the illustra-
tions.
Airgun
► P. 3, fig. 1
1. Air nozzle
2. Trigger
3. Hose connection
Tyre inflator
► P. 3, fig. 2
4. Hose
5. Pressure gauge
6. Pushbutton for air exhaust
7. Trigger
8. Locking lever
9. Valve connector
10. Hose connection
Supplied as standard
• Instructions for use
• Airgun
• Tyre inflator
• Compressed air hose
Operation
DANGER! Risk of injury! The prod-
uct or compressed air must not be
directed at oneself, others and ani-
mals.
Check before switching on!
Check the safe condition of the product:
• Check whether there are any visible
defects.
• Check all parts to make sure that they fit
tightly.
• Check whether the compressed air sys-
tem is pressurised.
• Check whether the compressed air con-
nection and pressure lines are sealed.
Compressed air supply
NOTICE! Risk of product damage!
Operate the product only with cleaned
and condensate-free compressed air.
Note: Always use screw thread seal-
ing tape (e.g. Teflon tape) when
screwing the plug-in coupling into the
product.
• Valves and hoses must be rated for pres-
sure and the required air flow.
• Always use a compressed air mainte-
nance unit with filter pressure reducer.
– Connect the compressed air hose to the
plug-in coupling and engage securely
(► P. 3, fig. 3).
Airgun
DANGER! Risk of injury! The blow-
ing out of blind holes and blowing on
of edges can cause excessive noises.
Always wear hearing protection when
handling the airgun.
– Press the trigger (2), to start the com-
pressed air supply.
– Release the trigger (2), to stop the com-
pressed air supply.
Tyre inflator
Note: Observe the manufacturer's
data for tyre pressure. The safety and
service life of the tyre depends on the
correct inflation pressure.
– Press the locking lever (8) and insert the
valve connector (9) up to the stop on the
tyre valve.
– Press the trigger (7), to start the com-
pressed air supply.
– Release the trigger (7), to stop the com-
pressed air supply.
GB
21
Publicité
