Publicité
Storage
1. Switch off the steam generator and disconnect the power plug. If you have
used the iron recently, allow the steam ironing station to cool down for at least
two hours.
2. Remove the water tank from the device and empty it completely.
3. Place the iron on the platform if you have not already done so. Slide the iron
lock to the right to secure the iron on the ironing surface.
4. Wrap up the power cord and slide it into the stowage tube on the lower right
side of the steam generator.
5. Generally carry the steam ironing station with both hands and store it in a
cool, light-protected place. Ideally, use the original packaging.
Problem solving
Problem
Possible cause
The iron produces no or little
The water tank is empty and
steam.
the "Water tank empty"
indicator lights up red.
The unit is not hot
hot enough to
generate.
The steam button was
not pressed.
The water tank is not
properly or completely
inserted.
The device has switched off.
The automatic switch-off
The display of the On/Off
has activated automatically
button flashes.
because the device has not
been used for at least 10
minutes.
The ironing board cover
Steam has condensed on
gets wet or during
the ironing board cover after
ironing, drops of water
long ironing.
get onto the fabric.
Solution
Fill the water tank
to be able to continue
ironing.
After switching on, wait until
the light of the SET button
lights up continuously.
Press and hold the steam
button during
pressed during ironing.
Push the water tank into the
device until it audibly clicks
into place.
To switch on the device,
press the On / Off button
again.
Replace the ironing board
cover if necessary when the
material wears out or place
an extra layer of fabric under
the ironing board cover to
prevent condensation.
23
Problem
Possible cause
Water drips from
The steam that was still in
from the iron soleplate.
the hose has cooled down
and condensed to water.
Steam and/or water escapes
The decalcification lock
from under the descaling
is not tightened.
cap.
Dirty water and impurities
Contaminants or chemicals
are leaking from the ironing
from the water have settled
soleplate or the ironing
in the nozzles or on the
soleplate is dirty.
soleplate.
Too many lime deposits and
minerals in the
accumulated.
The iron leaves shiny spots
The surface to be ironed was
or a mark on the fabric.
uneven, e.g. because you
pressed on ironed on the
fabric over a seam or a fold.
The device makes a
Water is pumped into the
pumping noise.
boiler of the unit. This is
normal.
Note
Hinweis
Bitte wenden Sie sich bei Fragen oder Unklarheiten an das KLAMER Customer-Support
Please contact the KLAMER Customer Support Team at hello@klamer-home.com with
Team unter hello@klamer-home.com. Wir helfen Ihnen gerne!
any questions or uncertainties. We are happy to help you!
Solution
Point the iron away from the
garment and let it generate
steam for about 30 seconds.
Switch off the device and let
it cool down for two hours.
Unscrew the descaling cap
and then screw it properly
back onto the device. Water
may leak out in the process.
Clean the iron soleplate with
a damp cloth.
Descale the device regularly.
The shine or imprint is not
permanent and disappears
when the garment is
washed.
If the pumping noise is heard
continuously, contact
KLAMER Customer Support.
24
Publicité
