Publicité
► P. 3, fig. 3
15. Display for remaining capacity
16. Push button for capacity display
17. Locking button
18. Indicator lights
19. Battery charger
Scope of delivery
• Drive unit
• Saw bar
• Saw chain
• Protective cover
• Battery pack (2×)
• Battery charger
• Instructions for use
Assembly
DANGER! Risk of injury during
operation! Improperly mounted parts
can cause severe and even fatal inju-
ries when using the device! This
device may only be commissioned if
all parts are mounted completely and
tightly and no part is damaged!
• Therefore, read the whole chapter
before you assemble the parts!
• Assemble the parts carefully and
completely.
• Use tools when their use is sug-
gested.
CAUTION! Risk of injuries due to
cuts! The teeth of the saw chain are
very sharp! Protective gloves must be
worn for all work on the chain.
WARNING! Risk of injury! An
improperly mounted saw chain
causes uncontrolled cutting behav-
iour of the device! When assembling
the chain, heed the prescribed run-
ning direction!
Assembling the saw bar and saw chain
– Release the chain brake (3) (move the
hand guard back and engage it).
► P. 4, fig. 4
– Unlock, undo the quick locking device (7)
and remove the chain wheel guard (8).
► P. 4, fig. 5
Note: When attaching the chain,
heed the correct position of the guide
groove (saw bar).
– Place the sawing chain onto the chain
wheel. Pay attention to the chain's correct
direction of rotation: the direction in
which the arrow points on the chain
must match the direction marked on
the chain wheel.
– Attach the saw bar and push it towards
the chain wheel.
– Insert the sawing chain into the guiding
groove of the saw bar.
– Route the sawing chain around the saw
bar. Ensure the correct location inside the
guiding groove.
► P. 4, fig. 6
– Attach the chain wheel cover. The chain
dowel spin must engage in the hole of the
saw bar.
– Now gently tighten the quick locking
device (7).
Tightening the chain
► P. 4, fig. 6
– Slightly lift the tip of the saw bar.
– Check if the sawing chain runs smoothly
by turning it manually.
– Turn the tensioning screw (6) until the
chain lies on the underside of the saw bar.
– Tighten and lock quick locking device (7).
Using for the first time
Charging the battery pack
WARNING! Risk of injury! Comply
with all safety instructions when han-
dling rechargeable devices.
NOTICE! Risk of damage to the
device! Charge the battery only at
ambient temperatures between 0 and
40°C. Charging outside of this tem-
perature range may damage the bat-
tery or increase the risk of fire.
NOTICE! Risk of damage to the
unit! Due to the high operating cur-
rent, the unit must only be operated
with batteries with a capacity of at
least 4 Ah (article number 196052).
Replacement batteries with article
number 196051 are not suitable for
operation with this unit.
NOTICE! Risk of damage to the
unit! Do not allow the battery pack to
deep discharge.
GB
61
Publicité
