Publicité
GB
Operation with two batteries
Note: The device may be operated
using one or two batteries.
– When the device switches itself off auto-
matically, release the switch-on lever.
– To activate the second battery, switch the
device on again.
Switching-off the device
– Release the switch on lever.
Mowing
WARNING! Risk of injury! Before
starting work, check the area and
remove all objects which may be
kicked up by the unit.
– Slowly engage and firmly hold clutch lever
for travel guide (10) up to the stop.
– Guide the unit at an even, slow pace
(walking speed) and with as straight a
path as possible.
Information on mulching
Note: Mulching is the use of cut
grass as a natural compost. When
mulch-mowing, the grass is cut,
finely chopped and spread across
the grass in one operation.
► Mounting the mulch wedge – p. 47
• Do not mulch moist grass.
• Regularly clean the mulch wedge, ejec-
tion channel and cutting blade.
Important notes
• Always work at right angles to the slope.
• Try not to cut grass when wet.
• Use overlapping paths to produce an
even cutting pattern.
• Cut longer grass with a greater cutting
height initially, then cut crosswise using
the desired cutting height.
► P. 5, fig. 9
• If the air flap (23) closes, the collection
container is full and must be emptied.
Cleaning and maintenance
DANGER! Risk of injury! Carry
out the maintenance work
described here in person.
Improper maintenance work can
damage the device and lead to inju-
ries.
48
DANGER! Risk of injury! Before
carrying out any maintenance or
cleaning work, the machine must be
disconnected from the power and
secured to prevent accidental
switch on.
Cleaning and maintenance overview
Before each use
What?
General function
check.
Check all screw con-
nections and tighten
if necessary.
Cleaning the device
Clean unit immediately after every use. Dried
grass remains are very hard, and are very dif-
ficult to remove.
– Remove grass remains with a brush, and
a plastic scraper if required (do not use
sharp implements).
– Remove deposits on the wheels.
– Wipe the tool with a damp cloth.
– Never clean the unit with water or high-
pressure jet.
Changing the blades
CAUTION! Risk of injury! Never
touch the blade on the cutting edge.
Wear gloves at all times when work-
ing with the blade.
Removing
► P. 7, fig. 15
– Loosen the blade screw (26).
– Remove the blade (27) carefully.
Installing
NOTICE! Risk of damage to the
device! Pay attention to the rota-
tion direction of the blade (arrow).
– Ensure the correct installation position:
the journals (28) must line up with the
holes in the blade.
– Carefully attach the blade (27).
– Tighten the blade screw (26).
Storage, transportation
► P. 7, fig. 14
How?
Visual check.
Hand-tighten the
screw connections us-
ing the appropriate
tool.
Publicité
