Etac Clean Mode D'emploi page 16

Etac / Clean / www.etac.com
More adjustment options are available by moving the pin.
Back support upholstery
User brake
Service and maintenance
Clean the device using a standard non-abrasive cleaning
agent (pH between 5 and 9). Rinse and dry.
Disinfect the device with 70% disinfectant solution.
The device requires no other maintenance.
The device and its accessories can be safely cleaned at
85°C for 3 minutes (unless otherwise stated). This applies
to reconditioning.
Constituent materials are resistant to common
disinfectants.
The following surface treatment methods have been used
Transport, storage and disposal
Storage
The device should be stored indoors in a dry place at a
temperature above 5°C. If the device has been stored for
a long time (more than four months), its function must be
checked by an expert before use.
When the foot support is removed, the supporting pins
E5
are exposed and present a risk of grazing the feet.
When the chair is adjusted to a height of 47.5 cm, the
lowest footrest position must not be used.
E11-E13
Risk of squeezing at rear wheel and chassis/brake.
to protect against corrosion:
Lacquered surfaces = Polyester powder coating
Non-lacquered steel surfaces = Fe/Zn-Ni
5-year guarantee against material and manufacturing
defects. For terms and conditions, see www.etac.com.
16
E7-E10