Publicité
Installation Guide (continued)
E Using the Rubber Cushion (Optional)
(If there is an existing Rear Support Bracket on the Fire Wall of Car.)
Cover Mounting Bolt © on the rear of the unit with Rubber Cushion (Optional), and mount it into exist-
ing Rear Support Bracket.
Rear Support Bracket
(existing on the car)
3. a) Plug the Power Connector ©.
b) Install the Trim Plate (0.
Trim Plate
4. After installation reconnect the negative (—) battery terminal.
To Remove the Unit
a) Remove the removable face plate.
(= Page 21.)
b} Remove the trim plate (0 with a screwdriver
as shown in the figure.
c) Pull out the unit while pushing the lock lever using a screwdriver.
d) Remove the unit pulling with both hands.
Lock Lever
Lock Lever
20
CO-DPX33/DP22EUC
Publicité
