Bosch B36CT Serie Manuel D'utilisation page 17

9.2 Temperature alarm
If the freezer compartment becomes too warm, the
temperature alarm will switch on.
A warning tone sounds and the set temperature (freezer
compartment) and flash.
CAUTION
During the thawing process, bacteria may multiply and
spoil the frozen food.
Do not refreeze partly or completely thawed food.
▶
Refreeze food only after cooking.
▶
The frozen items should no longer be stored for the
▶
maximum storage period.
The temperature alarm can be switched on in the following
cases:
¡ The appliance is switched on.
Do not store any food until the appliance has reached
the set temperature.
¡ Large quantities of fresh food are being placed inside.
Switch on Super freezing before placing large quantities
of food in the appliance.
¡ The freezer compartment door is open for too long.
Check whether the frozen food has defrosted or
thawed.
Switching off the temperature alarm
Press .
▶
a The warning tone is switched off.
a The temperature display (freezer compartment) briefly
indicates the warmest temperature reached in the
freezer compartment. The temperature display (freezer
compartment) then indicates the set temperature again.
a From this time on, the warmest temperature is
recalculated and saved.
10 Home Connect® Home Connect®
This appliance is network-capable. Connecting your
Home Connect®
appliance to a mobile device lets you control its functions
via the Home Connect® app.
The Home Connect® services are not available in every
country. The availability of the Home Connect® function
depends on the availability of Home Connect® services in
your country. You can find information on this at:
www.home-connect.com.
To be able to use Home Connect®, you must first set up
the connection to the WLAN home network (Wi-Fi
the Home Connect® app.
After switching on the appliance, wait at least 2 minutes
until internal device initialization is complete. Only then
should you set up Home Connect®.
The Home Connect® app guides you through the entire
registration process. Follow the instructions in the
Home Connect® app to implement the settings.
1 Wi-Fi is a registered trade mark of the Wi-Fi Alliance.
Tip: Follow the instructions in the Home Connect® app as
well.
Notes
¡ Also note the safety information in this instruction
manual and ensure that it is also observed when
operating the appliance using the Home Connect® app.
→ "Safety", Page 4
¡ Operating the appliance on the appliance itself always
takes priority. It is not possible to operate the appliance
using the Home Connect® app during this time.
10.1 Setting up the Home Connect® app
Install the Home Connect® app on your mobile device.
1.
Start the Home Connect® app and set up access for
2.
Home Connect®.
The Home Connect® app guides you through the entire
registration process.
10.2 Setting up Home Connect®
Requirements
¡ The Home Connect® app is installed on your mobile
device.
¡ The appliance receives signals from the WLAN home
network (Wi-Fi) at its installation location.
Open the Home Connect® app and scan the following
1.
QR code.
Follow the instructions in the Home Connect® app.
2.
10.3 Checking the signal strength
You should check the signal strength if no connection
could be established.
Press .
1.
1 ) and to
a lights up and the submenu display shows "Cn".
Press / repeatedly until the submenu display shows .
2.
a The submenu display shows a value between setting
(no reception) and (full reception).
Press .
3.
Note: The signal strength should be at least .
Home Connect® en-us
17