Publicité
IV. GETTING STARTED
4.1- Unpacking
• Remove the product from packaging
• Check if the product and accessories (if any) are intact.
4.2- Assembly
WARNING!
Before any intervention on product, always disconnect it from the air supply.
Fitting the quick connector
• This tool is supplied with two different male quick connectors:
EQ-4 – commonly used in Europe
EN-6 – mainly used in the UK
• Select the connector that is compatible with your air supply system.
• Apply PTFE tape (not included) to the screw threads of the quick connector. This will help
to maintain an air tight seal.
• Remove the protective plug from the air inlet (3).
• Using a spanner (not included) to fit the quick connector into the air inlet located at the base
of the handle.
Connecting to air supply
• Make sure the air tool is set at "OFF" position.
• Remove the protective cap from the air inlet (3).
• Connect the air tool to the air supply. Do not allow supply pressure to exceed the maximum
stated in Table 1.
• Ensure that all parts of the system (hoses, couplers, etc.) are correctly rated for the air
pressure to be used.
Setting tool power
• The tool speed/power can be adjusted by decreasing/increasing the air supply pressure. Do
not allow supply pressure to exceed the maximum stated in Table 1.
Attaching and removing drill bits and accessories
• WARNING! Always disconnect the tool from the air supply before fitting or removing drill
bits or other accessories.
• WARNING! Never run the drill while tightening the chuck or changing rotation direction.
• WARNING! Never install accessories with a maximum speed rating below the no-load
speed of the tool.
• Open the chuck by rotating the chuck collar counter-clockwise.
• Insert the selected drill bit or accessory.
• Close the chuck by rotating it clockwise and hand tighten.
• NOTE: Ensure the drill bit or accessory runs centrally and repeat above steps to correct the
position of the bit in the chuck if necessary.
Setting Forward / Reverse direction
• Rotation direction can be selected with Forward/Reverse lever (2).
• To change direction, tilt the lever to appropriate position.
• "F" for forward direction, while "R" for reverse direction.
Page 10 / 18
Publicité
