Publicité
RD-606i(A)_ENG_110414_RD-606i(A)_ENG 2011-05-04 오후 2:13 페이지 16
5.
Operate the selected component for playback.
• When playing back the program sources with surround
sound, refer to "ENJOYING SURROUND SOUND" on
page 18.
6.
Adjust the (overall) volume.
MASTER VOLUME
DOWN
UP
7.
To mute the sound.
MUTE
• "MUTING" is displayed.
• To resume the previous sound level, press it again.
8.
To listen with the headphones.
PHONES
• Be sure to switch the speakers off.
• When listening to a DTS or Dolby Digital program source,
if the headphones are plugged in and the SPEAKER
button is set to off, it enters the 2CH downmix mode
automatically. (For details, refer to "2CH downmix
mode"on page 18.)
■Note:
• Be careful not to set the volume too high when using
headphones.
All manuals and user guides at all-guides.com
9.
• The tone mode is
10.
• Each time these buttons are pressed, the tone mode is
OFF : To listen to a program source without the
■When the TONE is set to ON to adjust the tone
11.
• Each time these buttons are pressed, the tone is selected as
→ BASS ↔ TREBLE ↔ TONE: ON ←
12.
• The tone level can be adjusted within the range of -10 ~
• In general, we recommend the bass and treble to be
• Extreme settings at high volume may damage your
• If the tone display disappears, start from the step 9 again.
16
Adjusting the tone (bass and treble)
Enter the tone mode.
TONE
TO
N E :
displayed for several
FM
seconds.
Press the CURSOR LEFT(◀)/RIGHT(▶)
buttons to select the desired tone mode.
TUNE
selected as follows :
↕
tone effect.("DIR" lights up.)
ON : To adjust the tone for your taste.("DIR" goes off.)
(bass and treble).
Press the CURSOR UP(▲)/DOWN(▼) buttons
to select the desired tone.
PRESET
follows:
Press the CURSOR LEFT(◀)/RIGHT(▶)
buttons to adjust the selected tone as desired.
+10 dB.
adjusted to 0 dB (flat level).
speakers.
O F F
- 3 0
8 7
. 5 0
MH
z
P 0 1
Publicité
