Publicité
If you need to move your wine cellar
o
Unplug your cellar before any operation.
o
Remove all bottles from the cellar and secure the moving parts.
o
To avoid damaging the leg leveling screws, screw them all the way into their base.
o
Close the door completely.
o
Move the device to a vertical position preferably or note from the inscriptions on the packaging,
the direction in which the device can be laid. Also protect your device with a blanket or similar
cloth.
7. IN THE EVENT OF A BREAKDOWN
Despite the care we take during production, a breakdown can never be totally excluded. Before
contacting your retailer's after-sales department, please check that:
The appliance is properly plugged in
There is not a power cut in progress
The breakdown is not one of those described in the table at the end of this manual
IMPORTANT: if the power cable supplied is damaged, it must be replaced by the manufacturer,
a service centre approved by the brand or the retailer. In all events, it must be replaced by
qualified personnel in order to avoid any risk of injury.
IF THESE CHECKS REVEAL NOTHING, THEN CONTACT YOUR RETAILER'S AFTER-SALES
Unplug the appliance before carrying out any maintenance or repair work.
8. TROUBLE SHOOTING
Many problems can be solved easily, saving you the cost of a phone call to service. Try to resolve
your problem by following the suggestions below before calling for service.
PROBLEM
The cellar is not working
The wine cellar is not cold enough
The device turns on and off
frequently
Interior lighting does not work
DEPARTMENT.
CAUTION!
TROUBLESHOOTING SOLUTION GUIDE
The device is not plugged in.
The device is turned off.
The circuit breaker has tripped or a fuse has blown.
Check the set temperature.
The outdoor environment may require a higher setting.
The door is opened too frequently.
The door is not closed properly.
The door seal does not adhere completely.
The ambient temperature is higher than normal.
Many bottles have been added to the wine cellar.
The door is opened too frequently.
The door is not closed properly.
The temperature is not set correctly.
The door seal does not adhere completely.
The device is not plugged in.
The circuit breaker has tripped or a fuse has blown.
70
POSSIBLE CAUSE
Publicité
