Publicité
WARNING:
attached to a battery power unit, make sure
that the front guard is installed.
•
Make sure that the cutting attachment guard and
front guard are not damaged. Replace the cutting
attachment guard and front guard if they are
damaged.
•
Only use original spare parts.
To check the blade
The blade is designed and manufactured to withstand
the loads that edging of a lawn involves.
•
Check the blade for damage or cracks. A damaged
blade should always be replaced.
Work position
•
Hold the product with 2 hands.
•
Hold the product on the right side of your body.
•
Keep the cutting attachment below waist level.
•
Keep body parts away from the hot surfaces.
•
Keep body parts away from the cutting attachment.
To check the support flange
•
Check that the support flange is not cracked due to
fatigue or due to being tightened too much. Discard
the support flange if it is cracked.
8
If the cutting attachment is
To check the locknut
CAUTION:
locknut must not be so worn that you can
turn it by hand. The lining should offer a
resistance of minimum 13 in-lb / 1.5 Nm.
The locknut must be replaced after it has
been put on approximately 10 times.
CAUTION:
thread. To tighten the locknut to much can
cause damage to the threads.
The locknut secures the cutting attachment on the
output shaft. Protect your hand from injury when
assembling, use the cutting attachment guard as
protection when tightening with a socket wrench.
1. When fitting, tighten the locknut in the opposite
direction to the direction of rotation of the cutting
attachment. To remove it, undo the locknut in the
same direction as the cutting attachment rotates.
2. Put a small screwdriver or locking pin (A) in the hole
on the drive disc to lock the blade.
3. Tighten the locknut to a torque of 11-15 ft-lb / 15-20
Nm.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
•
Always stop the engine/motor before you do work
on the cutting attachment. The blade continues to
move after the throttle/power trigger is released. If
you have a gasoline operated product, remove the
spark plug cap from the spark plug. If you have a
battery operated product, remove the battery. Make
sure that the cutting attachment has stopped fully
before you do work on it.
The nylon lining inside the
The locknut has a left-hand
A
Read the safety
2105 - 002 - 12.07.2024
Publicité
