Publicité
•
Before using the product check that the bevel gear is
filled to ¾ with grease. Fill if necessary using special
grease.
To lubricate the flexible drive shaft
1. Loosen the 2 screws on the bevel gear.
2. Remove the shaft assembly.
3. Take a firm grip on the hollow shaft (A) and remove
the flexible drive shaft (B) from the opposite end of
the gear box.
4. Lubricate the entire length of the flexible drive shaft.
5. Put the flexible drive shaft in the tube. Turn the
flexible drive shaft when you put it into the bevel
gear to make sure that it correctly engages.
6. Attach the bevel gear on the drive shaft and tighten
the 2 screws. Refer to
gearbox on page 9 .
Weight
Weight, lb/kg
10
A
To install the shaft into the
Technical data
To replace the blade
1. Put a small screwdriver or locking pin (F) in the hole
on the drive disc (A) to lock the blade (B).
2. Loosen and remove the locknut (E).
3. Remove the support flange (D), retainer (C), blade
(B) and drive disc (A).
4. Examine the locknut, support flange, retainer and
drive disc. Replace any damaged parts.
5. Attach the drive disc on the output shaft. Make sure
that the outer edge of the drive disk is in hole of the
blade.
C
E
6. Install the new blade on the drive disc.
B
7. Install the support flange. The outer edge of the
support flange must push on the blade.
8. Install the support flange.
9. Install the locknut.
10. Tighten the locknut to a torque of 12-15 ft-lb / 15-20
Nm.
11. Remove the screwdriver or locking pin.
Note:
The locknut has a left-hand
thread.
A
B
D
ECA308
4.9/2.2
2105 - 002 - 12.07.2024
F
Publicité
