There are no serviceable parts inside the device except for the lamp and the fuse. Maintenance and service
operations are only to be carried out by authorized dealers.
Please refer to the instructions under "Installing/Replacing the lamp".
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Power supply:
Power consumption:
DMX-control-channels:
DMX-512-connection:
Sound-control:
Colour-wheel 1:
Colour-wheel 2:
Dimensions (LxWxH):
Weight:
Maximum ambient temperature T
Maximum housing temperature T
Min.distance from flammable surfaces:
Min.distance to lighted object:
Fuse:
Accessory:
GE HPL575 240V/575W 300h 3200K
GE HPL575X 240V/575W 1500h 3050K Longl
Barndoors for PCC-250/PCC-500
FUTURELIGHT EX-6/32 controller
FUTURELIGHT EX-8/32 controller
FUTURELIGHT CP-240 controller
Wizard-512 USB DMX-Software + Interface
Wizard-1024 USB DMX-Software + Interface
FUTURELIGHT DES-3 DMX-terminator 3-pin
FUTURELIGHT FS-1 for PCC-250/500
Please note: Every information is subject to change without prior notice. 12.06.2007 ©
230 V AC, 50 Hz ~
585 W
4
3-pin XLR
via built-in microphone
5 colours and white
4 colours, blackout and white
325 x 435 x 350 mm
12 kg
:
45° C
a
(steady state):
85° C
B
0.5 m
0.5 m
T 4 A, 250 V
No. 88315000
No. 88315700
No. 51840955
No. 51834046
No. 51834047
No. 51834265
No. 51860102
No. 51860110
No. 51834001
No. 51840956
44/84
00026543.DOC, Versiom 1.5