Publicité
OPERATING INSTRUCTIONS
WATER DRAINAGE
Ensure the air conditioner is turned off and
unplugged and that it is close to a floor drain before
setting up any drain option.
1. Drain Plug
When the internal drain pan becomes full, the
LED display will show error code FL. The air
conditioning, dehumidifying or fan action will stop.
Place the bottom drain outlet of the appliance over
the receptacle that it will drain into; this could be
a basement floor drain, a sink or similar. Remove
the bottom drain cover and allow the water to
completely drain. Replace the drain cover by
pressing firmly to ensure a tight fit and no leaks.
2. Continuous Drain
During dry mode, you may wish to install a
continuous drain option so that the air conditioner
will automatically drain collected water.
Remove the upper drain cover and attach the drain
hose that was provided with the air conditioner.
Place the open end of the drain hose over the
receptacle that it will drain into; this could be a
basement floor drain, a sink or similar.
Ensure that there are no kinks or bends in the drain
hose and that it goes straight down toward the floor.
The continuous drain is activated by gravity only.
If the hose is not positioned directly downwards,
water will not drain correctly.
NOTE: The included drain hose is 2m (6.5 feet)
long. The narrow end is to be attached to the drain
outlet. Insert the drain hose firly to ensure a tight fit
and no leaks.
CARE & MAINTENANCE
CLEANING
• Unplug the appliance before cleaning or
servicing.
• Clean the cabinet with a lukewarm damp cloth
and neutral detergent. Dry the cabinet with a
lint-free dry cloth.
• Do not use gasoline, paint thinner or other
chemicals to clean the appliance.
• Do not wash the appliance directly under a tap
or using a hose. It may cause electrical damage.
AIR FILTERS
The air filter should be cleaned every two weeks to
ensure efficient performance. In households with
animals, the air filters may need to be cleaned more
often and the external grills may need to be wiped
to prevent blocked air flow.
Use a vacuum cleaner to remove dust accumulations
from the filters. If it is very dirty, immerse in warm
water and rinse several times. The water should
never be hotter than 40°C (104°F). After washing,
leave the filter to dry completely before re-installing.
To access the filter:
1. Hold the exhaust hose, push it backward slightly
and then lift it up.
2. Remove the filter.
19
Publicité
