Publicité
INSTALLATION INSTRUCTIONS
WINDOW KIT ASSEMBLY
Step one: prepare the window sliders
1. Measure the window opening where the window
kit will be installed.
NOTE: Window kit length range 51cm ~ 160cm
(20" ~ 63")
2. Assemble as many sliders as necessary to fit the
window. If the window opening is less than the
minimum length of a single slider, use the slider
that has the hole in it and cut it to the correct
length. Make sure not to cut the end that has the
hole as this is necessary to attach the exhaust
hose adapter.
3. Use the window slider bolts to secure the
window sliders at the correct length.
EXHAUST HOSE
Pull out the hose
1. Rotate the exhaust hose gently backwards.
2. Pull out the exhaust hose.
INSTALLING THE WINDOW KIT
The instructions below can be used for a hung
window application (shown on the left) or an
optional sliding window application (shown on the
right).
1. Cut foam seals to the correct lengths and attach
them to position A and B on the window frame
as shown below.
B
A
2. Insert the window slider kit into the window
opening and close the window the secure it in
place.
3. Cut the foam pad to match the window kit and
attach it to position C as shown to decrease heat
loss.
11
B
A
Publicité
