Publicité
GETTING STARTED
SET-UP & ASSEMBLY
Location Requirements
In order to ensure the safe operation of the device, the
setup location must fulfil the following prerequisites:
• Place your appliance on a floor that is strong enough to support the
appliance when it is fully loaded.
• Place the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.
• This unit is not designed for use in a garage or any other outside installation.
• Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
• The device requires an adequate flow of air in order to operate correctly.
Leave a minimum of clearance of 6" inches around the appliance.
• WARNING! Do not close the ventilation openings in the device housing.
• The electrical socket must be easily accessible so that the power cord can be
disconnected easily, in the case of an emergency.
• The installation and assembly of this device in non-stationary setup location must
be carried out by a specialist, provided they guarantee the prerequisites for the safe
use of this device.
• For energy saving reasons please ensure that the door is closed when the
appliance is turned on.
Leveling Your Dry Ager
• On your dry ager there are 3, large
feet and 1, adjustable, small foot.
To level your Dry Ager, adjust the
small foot at the bottom.
8
Pro Smoker®: Owner's Manual - Reserve 300 Dry Ager
Adjustable Foot
Handle Installation
• The device comes with one metal
stainless steel handle. To install
simply screw them to the door
with the supplied screws.
To do this, slide the rubber seal on
the back of the door to the side to
lay open the predrilled holes. Use
the included screws to install the
handle on the door.
Electrical Requirements Guidelines
In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
• Before connecting the device, compare the connection data (voltage and frequency) on the
rating plate with those of your electrical network. This data must agree in order that no
damages occur in the device. If in doubt, ask your qualified electrician.
• The connection between the device and the electrical network may use a 10 foot long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs is
prohibited.
• Make sure that the power cable is undamaged and has not been installed under or over
hot or sharp surfaces.
• This unit is not designed to be installed in an RV or used with an inverter.
• The electrical outlet must be protected by a 16A safety cut-out switch.
• The electrical safety of the device is only guaranteed if the device is connected to a properly
installed protective conductor system. If in doubt, have the house installation checked over
by a qualified electrician.
• The manufacturer cannot be made responsible for damages that are caused by a missing or
damaged protective conductor.
© 2023 Pro Smoker
pro-smoker.com - Phone:
9
1-800-874-1949
Publicité
