Venmar EuroDesign EDJDN1 Serie Manuel D'installation, D'utilisation Et D'entretien page 17

Install the Hood (Standard Installation)
N OTE: Two installers are recommended because of the weight of this hood.
1 ] Run house power cable between service panel and hood location . For hood with power cable
access located on back of hood, run the house power cable into the hood through the strain
relief previously installed in step 6 on page 11 . For hood with power cable access located on top,
tighten the strain relief to the power cable before inserting the strain relief in the knockout hole .
2 ] Hang hood from (2) rear mounting screws previously installed . Slide hood back towards
wall until mounting screw heads are engaged in narrow end of keyhole slots in top of hood .
Tighten screws securely and maintain a hold on the hood until completing step 3 .
3 ] Secure the hood to the cabinet using two (2) no . 8 x 5/8" round head wood screws (included
in parts bag) . Insert one (1) screw per side, in the slots (as shown below) . Attach power cable
to the hood using the strain relief .
Screw previously
tightened in step 2 .
4 ] Connect ductwork to hood and use metal foil duct tape to make joints secure and air-tight .
Make sure the damper assembly (or round duct plate) enters the ductwork and that the damper
opens and closes freely .
HD0966
BACK OF HOOD
HD1005
DUCTED INSTALLATION ONLY
17