Venmar EuroDesign EDJDN1 Serie Manuel D'installation, D'utilisation Et D'entretien page 10

Prepare the Hood
1 ] If present, remove all protective polyfilm from the hood and/or parts .
2 ] Remove 2 screws from top of hood . Remove the adapter/damper from back of hood (see
3 ] Using the finger cup, remove the grease filters from the hood by pushing down
4 ] Using a 11/32" nutdriver or socket, remove the lock nut retaining the flange of the right cover
10
illustration below) . Keep the screws for further use .
HJ0206

filters out .
plate (shaded part on illustration below) to the inner back of hood (see insets) . Remove the
right cover plate retaining screws (7 screws), then set the blower cover along with its screws
and lock nut aside .
2 SCREWS
B
C
HD0963
5
6
1
7
BACK OF HOOD
lock nut
HO0279
2 SCREWS
4
3
2

and tilting