Venmar EuroDesign EDJDN1 Serie Manuel D'installation, D'utilisation Et D'entretien page 11

5 ] Remove the parts bag, taped on the inner back of hood, near the left corner . Remove the EZ1
brackets from inside the hood by cutting off the tie wrap . Discard the tie wrap .
PARTS BAG LOCATION
6 ] Remove Electrical Power Cable Knockout from top (vertical wiring) or back (horizontal wiring)
of hood . For knockout removed from back of hood, install an appropriate strain relief,
1/2" diameter (not included) . For knockout removed from top of hood, the strain relief will be
installed later .
ELECTRICAL
POWER CABLE
KNOCKOUT
HD0625
HR0132
EZ1 BRACKETS
11