Publicité
c. Move ahead the screwdriver to reach
the lower face of locking clip.
d. Pull the screwdriver up together with
the knob.
2. Using thin screwdriver lift up and remove
the plastic magnet holder.
3. Ignite the shaft manually without the
knob.
4. Turn the shaft on the minimum position.
5. With a thin screwdriver, adjust the bypass
screw position (A).
A
6. If you change:
• from natural gas G20 20 mbar to liquid
gas, fully tighten the bypass screw in.
• from liquid gas to natural gas G20 20
mbar, undo the bypass screw
approximately 1/4 of a turn.
3
2
1
7. Reassemble the magnet holder and the
knob.
WARNING!
Make sure the flame does not go out
when you quickly turn the knob from the
maximum position to the minimum
position.
3.5 Electrical connection
• Make sure that the rated voltage and type
of power on the rating plate agree with the
voltage and the power of the local power
supply.
• This appliance is supplied with a mains
cable. It has to be supplied with a correct
plug which can hold the load that the
rating plate rates. Make sure that you
install the plug in a correct socket.
• Always use a correctly installed
shockproof socket.
• Make sure that there is an access to the
mains plug after the installation.
• Do not pull the mains cable to disconnect
the appliance. Always pull the mains plug.
• There is a risk of fire when the appliance
is in connection with an extension cable,
an adapter or a multiple connection. Make
sure that the ground connection agrees
with the standards and regulations.
• Do not let the power cable to heat up to a
temperature higher than 90° C.
To prevent contact between the cable and the
appliance below the hob use the clamps
which are on the side of the cabinet.
ENGLISH
9
Publicité
