Publicité
If the burner accidentally goes out, turn
the control knob to the off position and try
to light the burner again after minimum 1
minute.
The spark generator can start
automatically when you switch on the
mains, after installation or a power cut. It
is normal.
Each control knob is surrounded by
highlighted numbers visible while
Residual Heat function operates.
The hob is supplied with StepPower. This
function allows you to set the power more
precisely from 9-1.
WARNING!
If you do not switch the knob to the off
position, after two hours a warning sound
is emitted and the symbols flash red. It
reminds you that the burner is on. To
stop the sound, touch
The flame that surrounds the
thermocouple is a pilot flame. It prevents
unexpected shutdown.
5.3 Turning the burner off
To put the flame out, turn the knob to the off
position
.
WARNING!
Always turn the flame down or switch it
off before you remove the pans from the
burner.
5.4 Minute Minder
You can use this function as a Minute Minder.
1. Touch
.
To activate the function.
,
,
or
.
2. Touch
or
time (00 - 99 minutes).
When the time comes to an end, the sound
operates and 00 flashes.
In the last minute the time decreases in
seconds, and the last 10 seconds the
timer emits a sound signal.
3. Touch
,
,
To stop the sound.
4. To stop the timer, touch longer
You can use the Minute Minder at any
time also if the appliance is off.
The function has no effect on the
operation of the burners.
5.5
Hob²Hood
It is an advanced automatic function which
connects the hob to a special hood. Both the
hob and the hood have an infrared signal
communicator. You can also operate the fan
from the hob manually.
Manual modes:
Mode
Manual light
H0
Off
HL
On
H1
On
H2
On
H3
On
To turn off the hood touch longer
H0 is displayed.
WARNING!
After end of cooking, the hood does not
turn off automatically. Turn it off
manually.
of the timer to set the
or
.
.
Fan speed
Off
Off
Level 1
Level 2
Level 3
till
ENGLISH
15
Publicité
