Publicité
8.1 What to do if...
Problem
There is no spark when you try to
activate the spark generator.
The flame extinguishes immediately
after ignition.
The flame ring is uneven.
The control panel brightness is re‐
duced or it switches off.
The control knob pilot lights turn on
after connecting the hob to the
mains or after a power outage.
Hob²Hood function does not work.
You cannot activate or operate
Hob²Hood and Minute Minder.
The display shows "E t"
does not shows up when knobs
are opened.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
Possible cause
The hob is not connected to an elec‐
trical supply or it is connected incor‐
rectly.
The fuse is blown.
Burner cap and crown are placed in‐
correctly.
Flame spreader is placed incorrect‐
ly.
Thermocouple is not heated up suf‐
ficiently.
Burner crown is blocked with food
residues.
The temperature of the plate is high.
To ensure long lifetime of the dis‐
play the brightness is reduced de‐
pending on the temperature of the
hob. Above a certain temperature
the control panel switches off.
Pilot light test.
You covered the control panel.
There is water or fat stains on the
control panel.
-
Selected Automatic Mode is A0.
also during the warranty period. The
information about guarantee period and
Authorised Service Centres are in the
guarantee booklet.
Remedy
Check if the hob is correctly connec‐
ted to the electrical supply.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Place the burner cap and crown cor‐
rectly.
Place the flame spreader correctly.
After lightning the flame, keep the
knob pushed for equal or less than
10 seconds.
Make sure that the injector is not
blocked and the burner crown is
clean.
Let the hob cool down.
Refer to "Installation".
Remove the object from the control
panel.
Clean the control panel.
Turn off the control knobs and wait
until the display is off or disconnect
the appliance to the main to return
to the initial condition.
Refer to "Daily use".
ENGLISH
21
Publicité
