Télécharger Imprimer la page

Frigidaire GCEH1642FS1 Instructions D'installation page 9

Publicité

MOBILE HOME INSTALLATION
1. Dryer MUST be exhausted outside (outdoors,
not beneath the mobile home) using metal
ducting that will not support combustion. Metal
ducting must be 4 inches (10.16 cm) in
diameter with no obstructions. Rigid metal duct
is preferred.
2. If dryer is exhausted through the floor and area
beneath the mobile home is enclosed, the
exhaust system MUST terminate outside the
enclosure with the termination securely fastened
to the mobile home structure.
3. Refer to page 3 for other important venting
requirements.
4. When installing a gas dryer into a mobile home,
a provision must be made for outside make up
air. This provision is to be not less than twice
the area of thedryer exhaust outlet.
5. Installation MUST conform to current
Manufactured Home Construction & Safety
Standard (which is a Federal Regulation Title
24 CFR-Part 32-80) or when such standard is
not applicable, with American National Standard
for Mobile Homes. In Canada, the CSA Z240 is
applicable.
WARNING
The laundry center is designed
under ANSI Z 21.5.1 for
HOME USE only.
UNPACKING
1. Using the four shipping carton corner posts (two on each side), carefully
lay the laundry center on its left side and remove the foam shipping
base.
Excessive weight. Use two or more people to
CAUTION
move Laundry Center.
2. Return laundry center to an upright position.
3. Remove the following from
the back side of the
washer:
4 bolts,
4 yellow plastic spacers,
3 metal "P" clamps.
4. Remove the service panel
from the front of the
washer.
5. Remove the 4 nuts and 6
large washers that attach
the 2 yellow shipping
braces to the
drum and
the base. Lift up on the
drum and remove the
braces (a yellow ribbon
surrounds the items to be
removed).
6. Remove the large
styrofoam block located
under the drum. Lift up on
the drum, tilt the base of
the foam block inwards
toward the rear of the
washer until free, then pull
it out.
7. Remove and discard the
yellow ribbon and label
from the front of the
washer.
8. Replace the service panel
and screws.
9. Carefully move the laundry
center to within 4 feet
(1.22m) of the final location
to begin the installation.
NOTE: If the laundry
center is to be
transported at a later
date, the shipping
support hardware must
be reinstalled to prevent
shipping damage.
SHIPPING CARTON CORNER POSTS
FOAM
SHIPPING
P AD
3
BOLT
3
SPACER
"P" CLAMP
5
4
8
7
5
6

Publicité

loading