Publicité
Example: To Repair Frame Damage
1. Determine which direction the frame needs to straighten.
2. Remove any obstructions that could be damaged or are in the way.
3. Connect the Flat Base to the stationary side of the Hydraulic Ram and connect the appropriate attachment
to the pushing end of the Stroke Ram.
Appropriate Attachment
4. Position the Hydraulic Ram so that the Flat Base is resting against a frame member opposite the damaged
area. It must also be in line with the direction in which the damaged area needs to be pushed.
5. Aim the pushing end towards the area that needs to be repaired and slowly apply pressure with the Pump
Unit. Once contact has been made on both points of contact, step away as far as possible and continue to
slowly apply pressure to the damaged area until the desired bend has been made.
CAUTION: Keep hands away from contact areas and tight spaces. The Portable Power Kit may slip and
cause injury.
6. When the damaged area has been bent to the desired position, slowly turn the Release Valve on the Pump
Unit in a counterclockwise direction to release the hydraulic pressure and cautiously remove the Hydraulic
Ram.
Hydraulic Ram
Flat Base
Male Connector
7
Publicité
