Publicité
TO ADD OIL TO HYDRAULIC PUMP UNIT:
After extensive use, the hydraulic oil supply should
be replaced to ensure longer equipment life.
1. Remove the oil plug.
2. Add 0.24 Qts (approximately 7.68oz./ 220ml) of
oil. The oil level should be near position A.
Use a high grade anti-foaming hydraulic oil.
KEEP DIRT AND OTHER MATERIALS CLEAR
WHEN POURING.
3. Replace the Oil oil plug.
4. Perform the Air Purge Procedure.
TO REPLACE OIL TO HYDRAULIC
PUMP UNIT :
1. Remove the oil plug.
2. Turn the Pump Unit on its side so that old oil will
drain from the oil fill hole.
3. Add 0.24 Qts (approximately 7.68oz./ 220ml) of
oil. The oil level should be near position A.
Use a high grade anti-foaming hydraulic oil.
KEEP DIRT AND OTHER MATERIALS CLEAR
WHEN POURING.
4. Replace the Oil oil plug.
5. Perform the Air Purge Procedure.
11
Publicité
