Publicité
GENERAL SAFETY RULES
WARNING: Read and understand all instructions. Failure to follow all instructions listed below may result
in serious injury.
CAUTION: Do not allow persons to operate or assemble this product until they have read this manual and
have developed a thorough understanding of how the product works.
WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions or situations that could occur. It must be understood by the operator
that common sense and caution are factors that cannot be built into this product, but must be supplied by
the operator.
PLEASE READ THESE INSTRUCTIONS CAREFULLY.NOTE THE SAFETY INSTRUCTIONS AND
WARNING. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE OF WHICH IT IS
INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE TO PROPERTY AND/OR SERIOUS PERSONAL
INJURY. PLEASE KEEP THIS INSTRUCTION MANUAL SAFE FOR FUTURE USE.
We've done all we can to assure this equipment offers the outmost in safety, but you have to do your part. No
amount of warning can take the place of your good judgment, so make sure it's the first thing you bring to any
job. Beyond that here are some obvious tips:
• Steel and other materials can shatter, so always use ANSI approved impact safety goggles, full-face impact
safety shield and heavy-duty work gloves when operating.
• Remove loose fitting clothing. Remove ties, watches, rings and other loose jewelry and contain long hair.
• Keep proper balance and footing, do not over-reach and wear nonskid footwear.
• Do not operate the when you are tired or under the influence of alcohol, drugs or an intoxicating medication.
• Keep hands and feet away from work area at all times.
• Do not allow untrained persons to operate the equipment.
• If you detect anything that may indicate imminent structural failure, stop using the product immediately and
inspect it thoroughly.
• Do not use to compress springs or any other item that could disengage and cause a potential flying hazard.
• Use this equipment for the purpose for which it is intended. Do not use it for any other purpose it is not
designed to perform.
• Keep children and unauthorized persons away from the work area.
• Only use this equipment on a surface that is stable, level, dry and not slippery, and capable of sustaining
the load. Keep the surface clean, tidy and free form unrelated materials and ensure that there is adequate
lighting.
• Inspect before each use. Do not use if bent, broke, cracked, leaking or otherwise damaged.
• Use extreme caution when working around any parts that are subjected to a shock load.
• Check to ensure that all applicable bolts and nuts are firmly tightened.
• Ensure that work piece is center-loaded and secure.
• Do not make any modifications to the equipment.
• Do not use brake fluid or any other improper fluid and avoid mixing different types of oil when adding
hydraulic oil. Only good quality hydraulic jack oil can be used in equipment.
• Do not expose the equipment to rain or any other kind of bad weather.
• If the equipment needs repairing and/or there are any parts that need to be replaced, have it repaired by
authorized technicians and only use the replacement parts supplied by the manufacturer.
WARNING: To reduce the risk of personal injury and/or property damage, ensure that the rated working
pressure of each pressurized attachment be equal to or greater than the rated working pressure
developed by the hydraulic pump.
Always check connections before using. Alteration of these products is strictly prohibited. Use only those
adapters and attachments provided and approved by the manufacturer
Note: when extension tubes and/or offset attachments are used, the rated capacity is always reduced by
50% for each tube or offset attachment connected.
GENERAL SAFETY RULES
IMPORTANT SAFETY CONSIDERATIONS
3
Publicité
