KitchenAid KVWC906KSS0 Instructions D'installation Et Guide D'utilisation Et D'entretien page 9

3. Install motor spring clip using two 4.2 x 8 mm screws. Screw
spring clip to the inside top or back (alternate location on
some models) of the range hood at the proper location for
the selected motor system. Slide the mounting tab of the
spring clip through the slot in the panel and secure with the
screws. Use the inside set of mounting holes for the single
motor system. Use the outside set of mounting holes for the
dual motor system.
B
A
A. 4.2 x 8 mm screws (3) for motor support bracket
B. 4.2 x 8 mm screws (2) for motor spring clip
C. Motor support bracket
D. Motor spring clip (single motor assembly location)
E. Motor spring clip (dual motor assembly location)
4. Install the 6 mm nuts to the outside top or outside back
(alternate location on some models) of the range hood at the
proper location for the selected motor system.
Two 6 mm nuts are required for the single motor system.
■
Clip nuts into the small square notches located at the left
and right end of the square vent opening.
Five 6 mm nuts are required for the dual motor system.
■
Clip nuts into the small square notches, one located in
the front of the square vent opening and the other four
located at the left and right ends of the square vent
opening.
A
A. Clip nut locations for dual motor assembly (5)
B. Clip nut locations for single motor assembly (2)
5. Mount range hood. See the "Install Range Hood" section.
Install Range Hood Internal Blower Motor
1. Install the range hood blower motor assembly inside the
range hood with the wiring connection to the left for the
single motor system and to front or top for the dual motor
system.
Single Blower Motor Assembly
A
A.Wiring connection
E
D
C
A
A
B
Dual Blower Motor Assembly
A.Wiring connection
2. Slide the left mounting plate fl ange under the motor
mounting bracket.
A B
A. Motor mounting bracket
B. Mounting plate left fl ange
3. Push the right end of the motor mounting plate up and snap
it into the spring tab.
NOTE: The spring tab should be outside the slot in the
mounting plate.
A. Motor mounting plate
B. Spring clip
A
A
B
9