Publicité
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le onctionnement.
INTERNAL BATTERY INFORMATION
This Normatec Elite control unit is equipped with a rechargeable lithium ion battery. The internal battery
is designed to allow use of the Normatec Elite anywhere—even when power outlets aren't available. The
Normatec Elite control unit may need to be plugged in before first use. A fully charged battery will provide
power for 3+ hours of continuous use. It takes approximately 5 hours to fully charge the battery when the
control unit is plugged in and not in use. The rechargeable lithium ion battery is intended to be changed
only by authorized service personnel with the use of a special service tool. Battery voltage and capacity:
7.2V, 5000 mAh / 7.38V, 4800 mAh
PRODUCT SPECIFICATIONS
• Normatec Elite Model: JPN11 -SH, JPN11-ST, JPN11-TL, JPN11-PH, JPN11-PS, JPN11-PT
• Hardware versions: V1.3, V1.4, V1.5, V1.6, V1.7, V1.8, V1.9, V1.10, V1.11, V1.12, V1.13, V1.14
• Normatec Elite Dimensions: 4" (width), 4" (depth), 8.5" (height); [10.2 cm (width), 10.2 cm (depth), 21.6
cm (height)]
• Normatec Elite Weight: 3.2 lbs [1.45 kg]
• Normatec Elite electrical requirement: 12V
• Maximum Air Pressure: 110 mm Hg
• Temperature (operating): +41° F to 104° F [+5° C to +40° C]
• Temperature (storage): -13° F to +158° F [-25° C to +70° C]
• Relative Humidity (operating): 15% to 93%, non-condensing
• Relative Humidity (storage): -25˚ C without relative humidity control; +70˚ C at relative humidity up to
93%, non-condensing
• Atmospheric pressure (storage and transportation): 190hPa to 1060hPa
• Atmospheric pressure (operating): 700hPa to 1060hPa
AC-DC ADAPTER
WARNING! Only use the AC-DC adapter model number SMS-01120400-S68 provided with the
device. Using a different adapter may cause the device to not operate correctly.
• Input: 100-240V
• Output: 12V
ELECTROMAGNETIC COMPATIBILITY
The information contained in this section (such as separation distances) is in general specifically written
with regard to the Normatec Elite. The numbers provided will not guarantee faultless operation but should
provide reasonable assurance of such. This information may not be applicable to other medical electrical
equipment; older equipment may be particularly susceptible to interference.
GENERAL NOTES
Medical electrical equipment requires special precautions regarding electromagnetic compatibility
(EMC) and needs to be installed and put into service according to the EMC information provided in this
document and the remainder of the instructions for use of this control unit.
1.5 A 50/60 Hz
DC minimum 4 A
DC 4 A
Publicité
